Detection Technology
Calibration steps of loop resistance tester
In order to ensure the accuracy of the measurement of the loop resistance tester. Before measurement, we must first calibrate the equipment to ensure safe and correct operation. Temperature range: working temperature 5-49.
Calibration steps for calibrating loop resistance tester:
Step 1: Open the meter cover, be careful not to damage the two wires connected to the power switch on the circuit board, put the three calibration regulators on the bottom right of the circuit board, and allow the meter to run for at least 1/2 hour under this environmental condition. And only after reaching self-balance can the test be started.
Step 2: Connect one end of the cable to the alligator clip, the other end to the banana plug, connect the two ends of the resistor with the alligator clip, three calibration regulators, the upper one is for "humidity" measurement, the middle one is for "impedance", and the lower one is It is "adjust the temperature with a small screwdriver", the clockwise direction is incremental adjustment, and the counterclockwise direction is decremental adjustment.
Step 3: Press the power switch and compare the "temperature", "humidity" and "resistance value" at the same time, press the power switch resistance again, how the loop resistance tester will calibrate and observe the LCD screen, close the watch cover, and tighten the four Fix the screw and press the power switch to confirm whether the blood glucose meter is working normally.
Use of lightning protection component tester | 2021/10/29 | reading769time Test skills of zinc oxide arrester tester | 2021/10/28 | reading742time return