Using a digital double clamp phase voltammeter for resistance measurement requires a few simple steps:

1. Select the item to be measured: This can be any item that needs to measure resistance and estimate resistance.

2. Insert the probe into the required socket. Usually, the digital double clamp phase voltammeter will have multiple sockets for testing the probe. Insert these or check if they are in the correct slots. Generally, they may be marked as COM for public, while others are marked as visible ohms. It is usually used in combination with a voltage measuring socket.

3. Turn on the digital double clamp phase voltammeter

4. To select the required range, you need to open the digital double clamp phase voltammeter and select the required range. The selected range should ensure that the best readings can be obtained. Usually, the digital dual clamp phase voltammeter function switch will be marked with the maximum resistance reading. Choose a resistance whose estimated value will be lower than but close to the maximum value of the range. In this way, accurate resistance measurements can be made.

5. Make a measurement When the digital double-clamp phase voltammeter is ready for measurement, the probe can be applied to the item that needs to be measured. If necessary, you can adjust the range.

6. Turn off the digital double-clamp phase volt-ampere meter once the resistance measurement is completed, you can turn off the digital double-clamp phase volt-ampere meter to save the battery. It is also wise to turn the function switch to the high voltage range. In this way, if the digital double-clamp phase voltammeter is used again for another type of reading, if the digital double-clamp phase voltammeter is used inadvertently without selecting the correct range and function, it will not cause Any damage.

The digital double clamp phase voltammeter is an ideal test equipment for measuring resistance. They are relatively cheap, and have high accuracy and general performance.